Dodge Journey: Housing, coolant outlet

Removal

Cooling
Fig. 78: COOLANT OUTLET CONNECTOR - 2.7L

  1. - BOLT (2)
  2. - BOLT (2)
  3. - COOLANT OUTLET CONNECTOR

WARNING: Do not remove pressure cap with the system hot and under pressure because serious burns from coolant can occur.

1. Drain cooling system.

2. Disconnect engine coolant temperature sensor connector.

3. Disconnect hoses at coolant outlet connector.

4. Remove bolts attaching coolant outlet connector.

5. Remove coolant outlet connector.

Installation

Cooling
Fig. 79: COOLANT OUTLET CONNECTOR - 2.7L

  1. - BOLT (2)
  2. - BOLT (2)
  3. - COOLANT OUTLET CONNECTOR

1. Clean sealing surfaces. Inspect gaskets for tears and cuts. Replace as necessary.

2. Install coolant outlet connector and tighten bolts to 12 N.m (105 in. lbs.).

3. Connect hoses at coolant outlet connector.

4. Connect engine coolant temperature sensor connector.

5. Fill cooling system.

    Heater, engine block
    Description 2.4L Fig. 70: BLOCK HEATER 2.4L ENGINE - RETAINING CLIP - BLOCK HEATER CAUTION: The power cord must be secured in its retainer clips, and not positioned so it co ...

    Pump, water
    Description 2.4L Fig. 80: WATER PUMP - WORLD ENGINE - ACCESSORY DRIVE BELT - WATER PUMP PULLEY - WATER PUMP The water pump (3) on the world engine is attached to the water pump adapter ...

    See also:

    Cleaning, Inspection
    CLEANING Drain cooling system and refill with clean water. Refer to drain and fill procedures in this service information . Run engine with radiator cap installed until upper radiator hose is ho ...

    Assembly
    HOUSING-AIR DISTRIBUTION NOTE: LHD model with A/C shown in illustrations. RHD and heater-only models similar. Fig. 115: Mode Door Levers-Removal/Installation 1. If removed, install the fo ...

    Solenoid, pressure control
    DESCRIPTION Fig. 415: Identifying Variable Line Pressure Components - PRESSURE CONTROL SOLENOID - LINE PRESSURE SENSOR - SHOULDER SCREW - VARIABLE LINE PRESSURE HEADER - MANUAL SHAFT ...


    0.0115