Dodge Journey: Valve, oil pressure relief
Removal
Fig. 285: Oil Pressure Relief Valve
- - RELIEF VALVE
- - SPRING
- - RETAINER CAP
1. Remove the oil pan.
2. Remove the pressure relief valve (1) by remove the threaded retaining cap from the oil pump housing.
CAUTION: Oil pump pressure relief valve must be installed as shown in illustration or engine damage may occur.
3. Remove spring and relief valve.
Installation
Fig. 286: Oil Pressure Relief Valve
- - RELIEF VALVE
- - SPRING
- - RETAINER CAP
1. Lubricate relief valve with oil.
CAUTION: The pressure relief valve must be installed as shown in illustration or engine damage may occur.
2. Install relief valve (1) , spring and retainer cap. Tighten cap to 12 N.m (105 in. lbs.).
3. Install the oil pan.
Switch, oil pressure
Description The engine oil pressure switch is located on the right side of the engine block. The switch screws into the engine main oil gallery. The normally closed switch provides an input throug ...Manifolds
...See also:
LIFTGATE
The liftgate can be unlocked or locked with the Remote
Keyless Entry (RKE) transmitter or by activating the
power door lock switch located on either front door trim
panel.
NOTE: The liftgate canno ...
Assembly
Fig. 333: Identifying Thrust Washer
- THRUST WASHER
NOTE: The differential is serviced as an assembly. Differential
service is limited to
bearing cups and cones. Any other differentia ...
REMOTE STARTING SYSTEM — IF EQUIPPED
This system uses the Remote Keyless Entry (RKE) transmitter
to start the engine conveniently from outside the
vehicle while still maintaining security. The system has a
range of approximately 300 f ...