Dodge Journey: Cooler and lines, oil
Description
Fig. 250: Oil Cooler Fasteners
Some 2.7L engines may be equipped with an engine oil cooler (2) that is mounted to the rear transmission mount bracket. Oil lines route oil from the engine block to the cooler, which is connected to the engine cooling system.
Removal
WARNING: If the engine is at or near normal operating temperature, the coolant is hot enough to cause severe burns. Always allow the engine to cool down before removing any cooling system hoses.
Fig. 251: Heater Hoses From Oil Cooler
1. Disconnect the heater hoses (1) from the oil cooler (5) and clamp them off.
Fig. 252: Cooler Line Retaining Bracket Fastener
2. Remove the oil filter.
3. Remove the oil filter adapter (2).
4. Remove the cooler line retaining bracket fastener (1).
Fig. 253: Oil Cooler Fasteners
5. Remove the oil cooler fasteners (1) and remove the oil cooler assembly (2).
Installation
Fig. 254: Oil Cooler Fasteners
1. Install the oil cooler (2) and install the fasteners (1). Tighten to 65 Nm (48 ft. lbs).
Fig. 255: Cooler Line Retaining Bracket Fastener
2. Install the oil cooler diverter (3) and install the oil filter adapter (2).
3. Reposition the oil line retaining bracket, and install the fastener (1). Tighten to 23 Nm (17 ft. lbs.).
4. Install the oil filter.
5. Top off the cooling system as necessary.
Description, Operation, Diagnosis and Testing
DESCRIPTION The lubrication system is a full-flow filtration, pressure feed type. The oil pump body is mounted to the engine block. The pump inner rotor is driven by the crankshaft. A structural w ...Filter, engine oil
Removal Fig. 256: Oil Filter & Drain Plug 1. Raise vehicle on hoist. 2. Position a suitable collecting container under oil filter location. 3. Remove oil filter (2) using a suitable oil ...See also:
Standard procedure, Cleaning, Inspection
Standard procedure
BATTERY RECONNECTION
NOTE: This reconnection procedure is to be performed anytime the
battery has been
disconnected.
1. Connect the negative battery cable remote termin ...
Description, Operation
DESCRIPTION
Fig. 29: Removing/Installing ECM - 2.0L Diesel
The ECM (3) is located in the left side of engine compartment attached to the
left inner fender below the air
filter housing.
OPERAT ...
Removal
FOOT OPERATED PARKING BRAKE LEVER
1. Release the parking brake.
2. Raise and support the vehicle.
3. Manually release the parking brake cable tension.
4. Push the front cable strand into ...