Dodge Journey: Insulator, engine mount, left
Removal
Fig. 228: Belly Pan
1. Disconnect and isolate the negative battery cable.
2. Remove throttle body air inlet hose and air cleaner housing assembly.
3. Remove the belly pan (2).
Fig. 229: Left Mount Vertical Bolts
4. Support transmission with floor jack and wooden block.
5. Remove the vertical bolts (1) from the left mount (2) to transmission bracket.
Fig. 230: Mount Isolator Bolts
6. Slightly lower transmission with floor jack to gain access to mount to frame rail fastener (2).
7. Remove mount isolator (3).
Installation
Fig. 231: Mount Isolator Bolts
1. Position mount isolator (3) in place, install bolts (1, 2) and tighten to 50 N.m (37 ft. lbs.).
Fig. 232: Identifying Left Engine Mount
2. Raise transaxle into position, install bolts (2) and tighten to 98 N.m (72 ft. lbs.).
3. Remove floor jack and wooden block.
Fig. 233: Belly Pan
4. Install belly pan (2).
5. Install throttle body air inlet hose and air cleaner housing assembly.
6. Connect negative battery cable.
Insulator, engine mount, front
Removal 1. Raise vehicle. Fig. 222: Belly Pan - belly pan fasteners - belly pan 2. Remove the belly pan (2). Fig. 223: Front Engine Mount Through Bolt 3. Remove front mount to bracket ...Insulator, engine mount, rear
Removal Fig. 234: Belly Pan 1. Remove throttle body air inlet hose and air cleaner housing assembly. 2. Raise the vehicle. 3. Remove the belly pan (2). Fig. 235: Identifying Rear Mount B ...See also:
Description, Operation
DESCRIPTION
The charging system consists of:
Generator
Decoupler Pulley (2.4L and Diesel Only)
Electronic Voltage Regulator (EVR) circuitry within the Powertrain
Control Module (PCM)
Ign ...
Installation
CLUTCH - FIXED DISPLACEMENT A/C COMPRESSOR
NOTE: Typical A/C compressor and clutch assembly shown in
illustrations.
Fig. 214: Clutch Coil & Snap Ring
1. Align the dowel pin on the bac ...
Removal, Installation
REMOVAL
Fig. 298: Identifying Transmission Connectors
- SOLENOID PACK CONNECTOR
- INPUT SPEED SENSOR CONNECTOR
- OUTPUT SPEED SENSOR CONNECTOR
- TRANSMISSION RANGE SENSOR CONNECTOR
...