Dodge Journey: Seal, crankshaft oil, rear
Removal
Fig. 214: REAR MAIN SEAL-INSTALLED
The crankshaft rear oil seal is incorporated in the seal adapter (2) and can not be removed from the adapter. The crankshaft rear oil seal/seal adapter (2) are serviced as an assembly.
Fig. 215: Flex Plate
1. Remove transmission.
2. Remove flex plate attaching bolts (2), backing plate (3), and flex plate (1).
3. Remove oil pan.
Fig. 216: REAR MAIN SEAL-INSTALLED
4. Remove seal retainer attaching screws.
5. Remove crankshaft rear oil seal/adapter (2).
Installation
Fig. 217: Oil Seal Retainer
NOTE: Inspect the crankshaft to make sure no nicks or burrs are on the seal surface.
1. Clean sealing surfaces thoroughly.
2. Apply engine oil to the seal lip inside diameter.
Fig. 218: REAR SEAL INSTALLED
NOTE: The seal lip (2) on the retainer must always uniformly curl inward toward the engine on the crankshaft (1).
Fig. 219: REAR MAIN INSTALLATION
3. Position the special tool 6926 (1) onto the crankshaft and gently slide the seal (2) over the crankshaft.
4. Install seal retaining bolts finger tight.
Fig. 220: REAR MAIN - SPECIAL TOOL 8225
NOTE: The following steps must be performed to prevent oil leaks at sealing joints.
5. Attach Special Tools 8225 (1) to pan rail using the oil pan fasteners.
NOTE: Make sure that the "2.7L" stamped on the special tool is facing the cylinder block (flat side of tools against pan rail).
NOTE: Make sure that the seal flange is flush with the block oil pan sealing surface.
6. While applying firm pressure to the seal assembly (2) against Special Tools 8225 (1), tighten seal assembly screws to 12 N.m (105 in. lbs.).
7. Remove special tool 8225.
8. Install oil pan.
Fig. 221: Flex Plate
9. Install flex plate (1), backing plate (3), and attaching bolts (2).
10. Install transmission.
11. Fill with oil (5).
12. Start engine and check for leaks.
Seal, crankshaft oil, front
Removal Fig. 212: Crankshaft Front Oil Seal - Removal - SPECIAL TOOL 6771 1. Remove crankshaft vibration damper. 2. Install Special Tool 8194, Insert into crankshaft nose. Remove seal us ...Engine mounting
...See also:
Installation
Fig. 51: Front Hub And Bearing Mounting
1. If required, install the hub and bearing (1) by sliding it into the
knuckle.
2. If installing hub and bearing, install the four bolts (2) fastening t ...
Engine diagnosis
ENGINE DIAGNOSIS - INTRODUCTION
Engine diagnosis is helpful in determining the causes of malfunctions not
detected and remedied by routine
maintenance.
These malfunctions may be classified as e ...
Duct, floor distribution, rear
REMOVAL
Fig. 159: Rear Floor Distribution Duct
1. Remove right quarter trim panel.
2. Remove the push-pin retainer (2) that secures the rear floor distribution
duct (1) to the right inner qu ...