Dodge Journey: Ring(s), piston
Standard Procedure
PISTON RING FITTING
Fig. 200: CHECK GAP ON PISTON RINGS
- - FEELER GAUGE
1. Wipe cylinder bore clean. Insert ring and push down with piston to ensure it is square in bore. The ring gap measurement must be made with the ring positioning at least 12 mm (0.50 inch.) from bottom of cylinder bore. Check gap with feeler gauge (1). Refer to Engine - Specifications for clearance measurements.
Fig. 201: Measuring Piston Ring Side Clearance
- - FEELER GAUGE
2. Check piston ring to groove clearance (1).
Removal
Fig. 202: PISTON RING - INSTALLATION
- - SPACER EXPANDER
- - SIDE RAIL
1. Remove piston and connecting rod.
2. Remove No. 1 and No. 2 piston rings from piston using a ring expander tool.
3. Remove upper oil ring side rail.
4. Remove lower oil ring side rail.
5. Remove oil ring expander.
Installation
Fig. 203: SIDE RAIL - INSTALLATION
- - SIDE RAIL END
1. Measure clearance of piston rings to the cylinder bore and piston.
CAUTION: Install piston rings in the following order:
- Oil ring expander.
- Upper oil ring side rail.
- Lower oil ring side rail.
- No. 2 Intermediate piston ring.
- No. 1 Upper piston ring.
2. Install oil ring expander.
Install the side rail (1) by placing one end between the piston ring groove and the oil ring expander. Hold end firmly and press down the portion to be installed until side rail is in position. Do not use a piston ring expander during this step.
3. Install upper side rail first and then the lower side rail.
Fig. 204: Upper and Intermediate Rings - Installation
NOTE: The No. 1 and No. 2 piston rings have a different cross section. Ensure No.
2 ring is installed with manufacturers I.D. mark (dot) facing up, towards top of the piston.
4. Install No. 2 piston ring and then No. 1 piston ring.
Fig. 205: PISTON RING END GAP POSITION
- - SIDE RAIL UPPER
- - NO. 1 RING GAP
- - PISTON PIN
- - SIDE RAIL LOWER
- - NO. 2 RING GAP AND SPACER EXPANDER GAP
Flexplate
Removal Fig. 198: Flex Plate 1. Remove transmission. 2. Remove flex plate attaching bolts (2). 3. Remove backing plate (3) and flex plate (1). Installation Fig. 199: FLEX PLATE 1. Posit ...Rod, piston and connecting
Description Fig. 206: Piston & Connecting Rod - "F" TOWARD FRONT OF ENGINE - RING COMPRESSOR - SPECIAL TOOL 8189 - OIL SQUIRT HOLE The pistons (1) are made of a high stre ...See also:
Removal
NOTE: Before proceeding, review all Warnings and Cautions.
1. Raise and support the vehicle.
Fig. 39: TIRE AND WHEEL MOUNTING
2. Remove the wheel mounting nuts (3), then the tire and wheel a ...
BRAKE SYSTEM
Your vehicle is equipped with dual hydraulic
brake systems. If either of the two hydraulic
systems loses normal capability, the remaining
system will still function. However, there will
be some ...
ALL WHEEL DRIVE (AWD) — IF EQUIPPED
This feature provides on-demand All-Wheel Drive
(AWD). The system is automatic with no driver inputs or
additional driving skills required. Under normal driving
conditions, the front wheels provide ...