Dodge Journey: Flexplate

Removal

2.7L DOHC Engine
Fig. 198: Flex Plate

1. Remove transmission.

2. Remove flex plate attaching bolts (2).

3. Remove backing plate (3) and flex plate (1).

Installation

2.7L DOHC Engine
Fig. 199: FLEX PLATE

1. Position the flex plate (1) with backing plate (3) on the crankshaft.

2. Apply Mopar Lock AND Seal Adhesive to the eight flex plate bolts (2).

3. Install the flex plate bolts (2). Tighten the bolts to 95 N.m (70 ft. lbs.).

4. Install the transaxle.

NOTE: The Cam/Crank Variation Relearn procedure must be performed anytime there has been a repair/replacement made to a powertrain system, for example: flywheel, valvetrain, camshaft and/or crankshaft sensors or components.

    Damper, vibration
    Removal Fig. 196: Vibration Damper - Removal - SPECIAL TOOL 8454 PULLER - SPECIAL TOOL 8194 INSERT 1. Disconnect negative battery cable. 2. Remove right front wheel and belt splash shie ...

    Ring(s), piston
    Standard Procedure PISTON RING FITTING Fig. 200: CHECK GAP ON PISTON RINGS - FEELER GAUGE 1. Wipe cylinder bore clean. Insert ring and push down with piston to ensure it is square in bore ...

    See also:

    ELECTRONIC VEHICLE INFORMATION CENTER (EVIC) — IF EQUIPPED
    The Electronic Vehicle Information Center (EVIC) features a driver-interactive display. It is located in the instrument cluster below the fuel and temperature gauges. Vehicles equipped with steerin ...

    Assembly
    Fig. 65: Remove Input Shaft Bearing Cup NOTE: Always use ATF on all moving parts during this assembly procedure. 1. Use Bearing Cup Remover 9664 (2) and appropriate Slide Hammer (1) to r ...

    Description, Operation
    DESCRIPTION Fig. 29: Removing/Installing ECM - 2.0L Diesel The ECM (3) is located in the left side of engine compartment attached to the left inner fender below the air filter housing. OPERAT ...


    0.0083