Dodge Journey: Damper, vibration
Removal
Fig. 196: Vibration Damper - Removal
- - SPECIAL TOOL 8454 PULLER
- - SPECIAL TOOL 8194 INSERT
1. Disconnect negative battery cable.
2. Remove right front wheel and belt splash shield.
3. Remove accessory drive belts.
4. Remove damper bolt.
5. Remove damper by using Special Tools 8194 Insert and 8454 Puller (1).
Installation
Fig. 197: Vibration Damper - Installation
- - VIBRATION DAMPER
- - SPECIAL TOOL 6792-1
- - SPECIAL TOOL 8179
1. Install damper using Special Tools 8179 (3) Screw, with Nut and Thrust Bearing from 6792, and 6792-1 Installer (2).
2. Install damper center bolt. Tighten center bolt to 170 N.m (125 ft. lbs.).
3. Install accessory drive belts.
4. Install belt splash shield and right front wheel.
5. Lower vehicle.
6. Connect negative battery cable.
Crankshaft
Description The crankshaft is constructed of a forged micro alloy steel. The six throw, nine counterweight crankshaft is supported by four select fit main bearings with the number three serving as ...Flexplate
Removal Fig. 198: Flex Plate 1. Remove transmission. 2. Remove flex plate attaching bolts (2). 3. Remove backing plate (3) and flex plate (1). Installation Fig. 199: FLEX PLATE 1. Posit ...See also:
Diagnosis and Testing
BRAKE ROTOR
Any servicing of the rotor requires extreme care to maintain the rotor within
service tolerances to ensure proper
brake action.
Excessive runout or wobble in a rotor can increase pe ...
MAINTENANCE SCHEDULE
The oil change indicator system will remind you that it is
time to take your vehicle in for scheduled maintenance.
On Electronic Vehicle Information Center (EVIC)
equipped vehicles “Oil Change Re ...
Cover(s), engine timing
Removal
Fig. 349: FRONT SPLASH SHIELDS
1. Disconnect and isolate negative battery cable.
2. Drain cooling system.
3. Remove coolant pressure container.
4. Remove right front wheel and bel ...