Dodge Journey: Electronically controlled clutch
REMOVAL
NOTE: Rubber coupler is part of the propeller shaft assembly. Removing coupler from propeller shaft will result in vibration/balance issues.
Fig. 95: Removing /Installing Propeller Shaft
1. Make sure transaxle is in neutral (N).
2. Raise vehicle on hoist.
3. Apply alignment index marks (4) on the rear axle flange (5) and rubber coupler (1).
4. Remove three rear propeller shaft rubber coupler to rear axle input flange retaining bolts (3).
5. Slide propeller shaft (2) back off rear axle input flange (5) and move out of the way as needed.
Fig. 96: Electrical Connector At ECC
6. Unplug the electrical connector at the ECC.
7. Remove the mounting bolts at the ECC.
8. Remove the ECC.
INSTALLATION
Fig. 97: Electrical Connector At ECC
1. Make sure transaxle is in Neutral (N) position.
2. Raise vehicle on hoist.
3. Install the ECC.
4. Install the mounting bolts at the ECC and tighten to 60 N.m (44 ft. lbs.).
5. Connect the electrical connector at the ECC.
Fig. 98: Removing /Installing Propeller Shaft
6. Align marks (4) on propeller shaft rubber coupler (1) to rear axle input flange (5).
7. Install three rear propeller shaft to rear axle retaining bolts (3) and tighten to 58 N.m (43 ft. lbs.).
8. Lower vehicle.
Seal, output flange
REMOVAL Fig. 93: Axle Seal Removal - SEAL - SCREWDRIVER 1. Raise vehicle on hoist. 2. Remove rear driveline module. 3. Use suitable screwdriver (2) to remove output seal (1). INSTA ...Electrical
...See also:
PARKING BRAKE
Before leaving the vehicle, make sure that the parking
brake is fully applied. Also, be certain to leave the
transmission in PARK.
The foot operated parking brake is located below the
lower left c ...
Description, Operation
DESCRIPTION
The generator is belt-driven by the engine. It is serviced only as a complete
assembly. If the generator fails for
any reason, the entire assembly must be replaced. The generator produ ...
Removal, Installation
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped
with airbags, disable
the Supplemental Restraint System (SRS) before attempting any steering
wheel, steering co ...