Dodge Journey: Seal, output flange
REMOVAL
Fig. 93: Axle Seal Removal
- - SEAL
- - SCREWDRIVER
1. Raise vehicle on hoist.
2. Remove rear driveline module.
3. Use suitable screwdriver (2) to remove output seal (1).
INSTALLATION
Fig. 94: Axle Seal Installation
- - HANDLE C-4171
- - INSTALLER 8493
1. Install output flange seal to differential housing using handle C- 4171A (1) and installer 8493 (2).
2. Install rear driveline module.
3. Check differential assembly fluid level and adjust as required.
Seal, input flange
REMOVAL Fig. 80: Removing /Installing Propeller Shaft NOTE: Rubber coupler is part of the propeller shaft assembly. Removing coupler from propeller shaft will result in vibration/balance i ...Electronically controlled clutch
REMOVAL NOTE: Rubber coupler is part of the propeller shaft assembly. Removing coupler from propeller shaft will result in vibration/balance issues. Fig. 95: Removing /Installing Propell ...See also:
Description
Fig. 1: Front Suspension Components
This vehicle has a gas pressurized MacPherson strut type front suspension
design.
Each side of the front suspension consists of these major components:
...
Description, Operation
DESCRIPTION
NOTE: LHD model shown. RHD model similar.
Fig. 226: Heater Core-Description
The heater core (1) for the heating-A/C system is mounted within the HVAC air
distribution housing, ...
Standard procedure
BASE BRAKE BLEEDING
NOTE: This bleeding procedure is only for the vehicle's base brakes
hydraulic system.
For bleeding the antilock brakes hydraulic system.
CAUTION: Before removing t ...