Dodge Journey: Fluid, differential
Standard Procedure
STANDARD PROCEDURE - DIFFERENTIAL ASSEMBLY FLUID CHANGE
Fig. 79: Differential Assembly Fluid Change
The drain plug (2) for the differential assembly is located in the bottom of the differential assembly case, toward the rear of the unit.
The fill plug (3) for the differential assembly is located on the left side of the assembly case.
The correct fill level is to the bottom of the fill plug hole. Be sure the vehicle is on a level surface, or is hoisted in a level manner, in order to obtain the correct fill level.
1. Raise the vehicle on a hoist.
2. Position a drain pan under the differential drain plug.
3. Remove the drain plug and allow the fluid to drain into the pan.
4. Install the drain plug and torque to 35 N.m (26 ft. lbs.).
5. Re-position the drain pan under the differential fill plug.
6. Remove the differential fill plug.
7. Using a suction gun or equivalent, fill the differential assembly with 0.7 L (0.74 Quarts) of Mopar Gear and Axle Lubricant (75W-90).
8. Install the fill plug and torque to 35 N.m (26 ft. lbs.).
Case assembly, differential
DESCRIPTION The differential gear system divides the torque between the axle shafts. It allows the axle shafts to rotate at different speeds when turning corners. Each differential side gear is s ...Seal, input flange
REMOVAL Fig. 80: Removing /Installing Propeller Shaft NOTE: Rubber coupler is part of the propeller shaft assembly. Removing coupler from propeller shaft will result in vibration/balance i ...See also:
Description
Fig. 422: Identifying Torque Converter Components
- TURBINE
- IMPELLER
- HUB
- STATOR
- CONVERTER CLUTCH DISC
- DRIVE PLATE
The torque converter is a hydraulic device that couples t ...
IF YOUR ENGINE OVERHEATS
In any of the following situations, you can reduce the
potential for overheating by taking the appropriate action.
• On the highways — Slow down.
• In city traffic — While stopped, put the ...
Description
MANUAL TEMPERATURE CONTROL (MTC) SINGLE ZONE
The A/C-heater control for the front Manual Temperature Control (MTC) single
zone system allows one
temperature setting for the entire vehicle. All con ...