Dodge Journey: Installation
Fig. 67: Seal Protector
- - HALFSHAFT
- - SEAL PROTECTOR
1. Install driveline module to transmission jack. Secure module to jack.
2. Using Seal Protector 9099 (2), load halfshafts to differential, one side at a time. Clean tool and seal area to prevent debris intrusion.
Fig. 68: Support Module With Jack
- - DRIVELINE MODULE
- - TRANSMISSION JACK
3. Raise driveline module (1) into position.
Fig. 69: Removing /Installing Propeller Shaft
4. Align marks (4) on propeller shaft rubber coupler (1) to rear axle input flange (5).
5. Install three rear propeller shaft to rear axle retaining bolts (3) but do not tighten at this time.
Fig. 70: RDA To Crossmember Bolts
6. Install the RDA - to - crossmember mounting bolts (1) and tighten to 102 N.m (75 ft. lbs.).
Fig. 71: Rear RDA Module-To-Crossmember Bolt
7. Install the rear RDA - to - crossmember mounting bolt (2) to 102 N.m (75 ft. lbs.)
8. Tighten propeller shaft-to-driveline module bolts to 58 N.m (43 ft.lbs.).
9. Raise exhaust system into position and install hanger/brackets.
10. Fill differential with 0.7L (0.74 Quarts) of Mopar Gear and Axle Lubricant (75W-90).
SPECIFICATIONS
SPECIAL TOOLS
Fig. 72: Flange Wrench, C-3281
Fig. 73: Installer 8493
Fig. 74: Installer 9231A
Fig. 75: Protector, 9099
Fig. 76: Universal Handle C-4171
Removal
Fig. 60: Support Module With Jack - DRIVELINE MODULE - TRANSMISSION JACK NOTE: Rear suspension and drivetrain design require this procedure to be performed on a "drive-on" ...Case assembly, differential
DESCRIPTION The differential gear system divides the torque between the axle shafts. It allows the axle shafts to rotate at different speeds when turning corners. Each differential side gear is s ...See also:
TIRE SAFETY INFORMATION
Tire Markings
1 — U.S. DOT Safety Standards Code (TIN).
4 — Maximum Load.
2 — Size Designation.
5 — Maximum Pressure.
3 — Service Description.
6 — Treadwear, Traction and Temperatu ...
Cover(s), cylinder head, right
REMOVAL
1. Disconnect negative battery cable.
Fig. 126: Engine Harness Retaining Clips
- Left cylinder head cover engine harness retainers
- Right cylinder head cover engine harness retainer ...
Disassembly, Assembly
Disassembly
NOTE: Before disassembling the brake caliper, remove it from the
vehicle.
NOTE: Before disassembling the brake caliper, clean and inspect it.
WARNING: Under no condition sh ...