Dodge Journey: Intermediate shaft, gas
REMOVAL
2.4L
1. Remove the right half shaft.
Fig. 44: Intermediate Shaft - 2.4L
2. Remove the three intermediate shaft bolts (1).
3. Remove the intermediate shaft (2).
2.7L
1. Remove the right half shaft.
Fig. 45: Identifying Intermediate Shaft, Heat Shield & Bolts
2. Remove the heat shield bolts (2).
3. Remove the heat shield (3).
4. Remove the intermediate shaft bolts (1) and (5).
5. Remove the intermediate shaft (4).
3.5L
1. Remove the right half shaft.
Fig. 46: 3.5L Right Half Shaft Components
2. Remove the intermediate shaft bolts (1).
3. Remove the heat shield bolts (2).
4. Remove the heat shield (3).
5. Remove the intermediate shaft (4).
INSTALLATION
2.4L
Fig. 47: Intermediate Shaft - 2.4L
1. Install the intermediate shaft (2).
2. Install the three intermediate shaft bolts (1).
3. Install the right half shaft.
2.7L
Fig. 48: Identifying Intermediate Shaft, Heat Shield & Bolts
1. Install the intermediate shaft (4).
2. Install the intermediate shaft bolts (1) and (5). Tighten bolt (1) to 38 Nm (28 ft. lb.) and bolts (5) to 23 Nm (17 ft. lb.).
3. Install the heat shield (3).
4. Install the heat shield bolts (2).
5. Install the right half shaft.
3.5L
Fig. 49: 3.5L Right Half Shaft Components
1. Install the intermediate shaft (4).
2. Install the intermediate shaft bolts (1) and tighten to 38 Nm (28 ft. lb.).
3. Install the heat shield (3).
4. Install the heat shield bolts (2) and tighten to 10 Nm (7 ft. lb).
5. Install the right half shaft.
Installation
Fig. 40: Seal Protector - HALFSHAFT - SEAL PROTECTOR 1. Install halfshaft to hub/bearing assembly. Install hub nut and washer but do not tighten at this time. 2. Using Seal Protector 9 ...Intermediate shaft, diesel
REMOVAL 2.0L DIESEL 1. Remove the right half shaft. Fig. 50: 2.0L Diesel Right Half Shaft Components 2. Remove the two intermediate shaft bolts (1). 3. Remove the intermediate shaft (2). ...See also:
Removal
BEVERAGE COOLER
WARNING: Disable the airbag system before attempting any steering
wheel, steering
column, or instrument panel component diagnosis or service. Disconnect
and isolate t ...
JUMP-STARTING
If your vehicle has a discharged battery it can be jumpstarted
using a set of jumper cables and a battery in
another vehicle or by using a portable battery booster
pack. Jump-starting can be danger ...
Actuator, blend door, rear
DESCRIPTION
Fig. 47: Rear Actuator Description
The blend door actuator (1) for the rear heating-A/C system is a reversible,
12 volt direct current (DC), servo
motor. The rear blend door actuato ...