With intermediate shaft

NOTE: The inner tripod joints are designed with a retention feature that prevents the tripod rollers from coming out of the inner joint housing up to a specific load. If this feature is o ...

Removal

Fig. 25: Outer C/V Joint Seal Boot Clamps - SMALL CLAMP - SEALING BOOT - OUTER CV JOINT HOUSING - LARGE CLAMP - INTERCONNECTING SHAFT 1. Remove halfshaft assembly requiring boot repla ...

See also:

Motor, headlamp leveling, export
DESCRIPTION Fig. 37: Headlamp Leveling Motor The headlamp leveling motor (1) is located on the rear surface of each front lamp unit on vehicles equipped with the headlamp leveling system, which ...

Description, Operation
DESCRIPTION Fig. 1: COOLING SYSTEM - OVERVIEW - WINDSHIELD WASHER RESERVOIR - UPPER SUPPORT - FAN SHROUD - FAN MOTOR - LOWER RADIATOR HOSE The cooling system consists of an engine co ...

Fluid, differential
Standard Procedure STANDARD PROCEDURE - DIFFERENTIAL ASSEMBLY FLUID CHANGE Fig. 79: Differential Assembly Fluid Change The drain plug (2) for the differential assembly is located in the bottom of ...