Dodge Journey: Tubes and hoses, brake
DESCRIPTION
The brake tubes are steel with a corrosion-resistant nylon coating applied to the external surfaces.
The flex hoses used at each wheel brake are made of reinforced rubber with fittings at each end. The fitting at each brake caliper is the banjo-type and requires a special banjo bolt and copper washers.
OPERATION
The purpose of the chassis brake tubes and flex hoses is to transfer the pressurized brake fluid developed by the master cylinder to the wheel brakes of the vehicle. The flex hoses are made of rubber to allow for the movement of the vehicle's suspension.
INSPECTION
Brake tubing should be inspected periodically for evidence of physical damage or contact with moving or hot components.
Flexible rubber hose is used at both the front and rear wheel brakes. Inspection of the flexible brake hoses should be performed whenever the brake system is serviced and every 12,000 km (7,500 miles) or 12 months, whichever comes first. Inspect hydraulic brake hoses for surface cracking, scuffing, or worn spots. If the fabric casing of the hose becomes exposed due to cracks or abrasions in the hose cover, the hose should be replaced immediately. Eventual deterioration of the hose can take place with possible burst failure. Faulty installation can cause twisting, resulting in wheel, tire, or chassis interference.
NOTE: This vehicle is equipped with more than one size (diameter) brake tube depending on location on the vehicle. If a brake tube must be replaced, always use the same size brake tubing as that being replaced. Never use under-size brake tubing.
Installation
FRONT NOTE: Inspect disc brake pads before installation. Fig. 169: VENTED BRAKE ROTOR MOUNTING 1. Clean the hub face (1) to remove any dirt or corrosion where the rotor mounts. 2. Insta ...Parking brake
...See also:
Diagnosis and Testing
REFRIGERANT SYSTEM LEAKS
WARNING: R-134a service equipment or vehicle A/C system should not
be pressure
tested or leak tested with compressed air. Mixture of air and R-134a can
be co ...
CHILL ZONE BEVERAGE COOLER STORAGE COMPARTMENT
The Chill Zone Beverage Cooler Storage Compartment
can keep chilled beverages cool depending on ambient
temperature and climate control setting. Chill Zone is
intended for nonperishable beverages o ...
Unit, heater
DESCRIPTION
Fig. 323: Positive Temperature Coefficient Heater - Description
NOTE: LHD model shown. RHD model similar.
An electric positive temperature coefficient (PTC) heater unit (1) is us ...