Dodge Journey: Pads, brake, rear
Installation
NOTE: Perform 1 through 5 on each side of the vehicle to complete pad set installation, then proceed to 6. NOTE: Make sure that the audible wear indicator (if equipped) is placed toward ...Removal
1. Raise and support vehicle. NOTE: Perform 2 through 5 on each side of vehicle to complete pad set removal. Fig. 124: TIRE AND WHEEL MOUNTING 2. Remove wheel mounting nuts (3), then tire ...See also:
Specifications
2.7L ENGINE
GENERAL SPECIFICATIONS
CYLINDER BLOCK
PISTONS
PISTON PINS
PISTON RINGS
PISTON RING SIDE CLEARANCE
PISTON RING WIDTH
CONNECTING RODS
CRANKSHAFT MA ...
Installation
Fig. 474: Removing/Installing Valve Body
- VALVE BODY
NOTE: If valve body assembly is being replaced or reconditioned, it is
necessary to
perform the PCM Quick Learn Procedure.
1. ...
Ring(s), piston
Standard Procedure
PISTON RING FITTING
Fig. 200: CHECK GAP ON PISTON RINGS
- FEELER GAUGE
1. Wipe cylinder bore clean. Insert ring and push down with piston to ensure
it is square in bore ...