Installation

LEFT-HAND-DRIVE NOTE: The master cylinder must be bled before installing it on the vehicle. 1. Bench bleed the master cylinder. 2. Wipe the face of the power brake booster clean where the ...

Removal

1. Raise and support the vehicle. NOTE: Perform 2 through 5 on each side of the vehicle to complete pad set removal. Fig. 117: TIRE AND WHEEL MOUNTING 2. Remove the wheel mounting nuts ...

See also:

Switch, backup lamp
REMOVAL Fig. 249: Back-Up Lamp Switch 1. Disconnect battery negative cable. 2. Raise vehicle on hoist. 3. Disconnect backup lamp switch connector. 4. Remove backup lamp switch (1). INSTA ...

EMISSIONS INSPECTION AND MAINTENANCE PROGRAMS
In some localities, it may be a legal requirement to pass an inspection of this vehicle’s emissions control system. Failure to pass could prevent vehicle registration. For states that require a ...

Seal(s), valve guide
REMOVAL Fig. 139: Valve Stem Seal-Removal/Installation - VALVE SEAL TOOL - VALVE STEM 1. Remove valve spring. 2. Remove valve stem seal by using a valve seal tool. INSTALLATION Fig. ...