Fluid

Diagnosis and Testing BRAKE FLUID CONTAMINATION Indications of fluid contamination are swollen or deteriorated rubber parts. Swelling indicates the presence of petroleum in the brake fluid. To ...

Description, Operation

DESCRIPTION Fig. 87: PRIMARY AND SECONDARY BRAKE TUBES All master cylinders (2) are a two-outlet design and the brake tubes from these primary and secondary outlet ports lead directly to the In ...

See also:

Heater performance
Before performing the following tests, see COOLING for the procedures to check the engine coolant level and flow, engine coolant reserve/recovery system operation, accessory drive belt condition ...

Diagnosis and testing
SHIFT INTERLOCK SYSTEM Fig. 421: Identifying Ignition Key/Switch Positions - LOCK - ACC - ON - START The Shifter Response Table describes the normal operation of the Brak ...

Assembly
Fig. 214: First Gear Needle Bearing & Output Shaft NOTE: Use ATF on all parts that are to be assembled in this procedure. 1. Install the first and first gear needle bearing (2) on the out ...