Installation

1. Completely retract the caliper piston back into the bore of the caliper. Use a C-clamp to retract the piston. Place a wood block over the piston before installing the C-clamp to avoid damagi ...

Removal

1. Disconnect and isolate battery negative cable from battery post. Fig. 70: BRAKE PEDAL HOLDING TOOL 2. Using a brake pedal holding tool as shown, depress brake pedal past its first inch of tra ...

See also:

Diagnosis and testing
SHIFT INTERLOCK SYSTEM Fig. 421: Identifying Ignition Key/Switch Positions - LOCK - ACC - ON - START The Shifter Response Table describes the normal operation of the Brak ...

Seal, input flange
REMOVAL Fig. 80: Removing /Installing Propeller Shaft NOTE: Rubber coupler is part of the propeller shaft assembly. Removing coupler from propeller shaft will result in vibration/balance i ...

Standard procedure
CYLINDER HEAD OIL GALLERY CUP PLUG SERVICE Fig. 92: Oil Gallery Cup Plug - CUP PLUG BORE CHAMFER - ORIGINAL CUP PLUG - NEW CUP PLUG - 1-2 mm NOTE: DETERMINE WHICH CUP PLUG IS LEAKIN ...