Installation

LEFT-HAND-DRIVE Fig. 35: BOOSTER SEAL NOTE: Before power brake booster (1) installation, be certain a NEW dash seal (2) is installed on the booster mounting studs. Fig. 36: PEDAL AND ...

Removal

Fig. 56: BRAKE PEDAL HOLDING TOOL 1. Using a brake pedal holding tool as shown, depress the brake pedal past its first one inch (25 mm) of travel and hold it in this position. This will isolate ...

See also:

Removal, Installation
REMOVAL WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negat ...

Switch, backup lamp
REMOVAL Fig. 249: Back-Up Lamp Switch 1. Disconnect battery negative cable. 2. Raise vehicle on hoist. 3. Disconnect backup lamp switch connector. 4. Remove backup lamp switch (1). INSTA ...

Heater, engine block
Description 2.4L Fig. 70: BLOCK HEATER 2.4L ENGINE - RETAINING CLIP - BLOCK HEATER CAUTION: The power cord must be secured in its retainer clips, and not positioned so it co ...