Description

Four-wheel disc brakes are standard on this vehicle. Each disc brake assembly consists of the following major components: Caliper Caliper adapter bracket Pads (Shoe and lining assemblies) ...

Description, Diagnosis and Testing

Description Fig. 17: PEDAL AND BOOSTER MOUNTING - LHD The power brake booster (3) is mounted to the engine side of the dash panel. The master cylinder is bolted to the front of the booster. A v ...

See also:

Description - monitored systems
There are new electronic circuit monitors that check fuel, emission, engine and ignition performance. These monitors use information from various sensor circuits to indicate the overall operation ...

Assembly
NOTE: Cleanliness through entire disassembly and assembly of the valve body cannot be overemphasized. When disassembling, each part should be washed in a suitable solvent, then dried by comp ...

Description, Operation
DESCRIPTION A Macpherson type design strut assembly is used in place of the traditional front suspension upper control arm and upper ball joint. The bottom of the strut mounts directly to the stee ...