Adjustments

ADJUSTMENT - LATE PRODUCTION TYPE ONLY Two unique brake lamp switches are used in this vehicle, depending upon whether the vehicle was built during early or late production. These switches are not ...

Standard procedure, Removal

STANDARD PROCEDURE FRONT LAMP UNIT MOISTURE CLEARING Some occasional moisture accumulation inside a vented front lamp unit is normal and appears as a fogging on the inside of the lamp lens, simil ...

See also:

Installation
Fig. 51: Front Hub And Bearing Mounting 1. If required, install the hub and bearing (1) by sliding it into the knuckle. 2. If installing hub and bearing, install the four bolts (2) fastening t ...

Synchronizer
DISASSEMBLY Place synchronizer in a clean shop towel and wrap. Press on inner hub. Carefully open up shop towel and remove springs, balls, keys, hub, and sleeve. CLEANING Do not attempt to clean ...

Removal
2.4L Fig. 45: Locating Knock Sensor The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold. 1. Disconnect and isolate negative battery ca ...