Dodge Journey: Switch, stop lamp

Removal, Installation
REMOVAL WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering co ...

Description, Operation
DESCRIPTION Two unique brake lamp switches are used in this vehicle, depending upon whether the vehicle was built during early or late production. These switches are not interchangeable and both a ...

See also:

Sensor, speed, output
DESCRIPTION Fig. 378: Identifying Output Speed Sensor - OUTPUT SPEED SENSOR The Output Speed Sensor (1) is a two-wire magnetic pickup device that generates an AC signal as rotation occurs ...

Installation
CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system. Failure to properly adjust the refrigerant oil level will prevent the A/C system fro ...

Description, Operation
DESCRIPTION Fig. 29: Removing/Installing ECM - 2.0L Diesel The ECM (3) is located in the left side of engine compartment attached to the left inner fender below the air filter housing. OPERAT ...

0.0163