Lamp, side repeater, export

REMOVAL BULB NOTE: Side repeater lamps are used only on vehicles manufactured for certain export markets where they are required. Fig. 20: Remove/Install Repeater Lamp Bulb 1. Disconne ...

Removal

BULB Each rear lamp unit for this vehicle consists of two pieces. An outer rear lamp unit that is secured at the rear of each quarter panel includes bulbs for the park (or tail) lamps, the brake ( ...

See also:

Actuator, mode door, rear
DESCRIPTION Fig. 51: Rear Actuator Description The mode door actuator (1) for the rear heater-A/C system is a reversible, 12 volt direct current (DC), servo motor. The rear mode door actuator i ...

Knob, gearshift
REMOVAL Fig. 357: Removing/Installing Gearshift Knob 1. Loosen the set screw (3) on the shift knob (2). 2. Hold in the shift knob button (1). 3. Pull up on the shift knob (2) while holding t ...

Fascia, rear
REMOVAL Fig. 15: Push Pins 1. Open the hatch. 2. Remove the 6 pushpins (1) securing the fascia (2). Fig. 16: Rivets 3. Remove the rivets (2) and the Torx screw (3) around the wheel well for ...