Frame and Bumpers

...

Fascia, front

REMOVAL Fig. 1: Pushpins 1. Release hood latch and open hood. 2. Remove the pushpins for the fascia (2) at the radiator support. Fig. 2: Pop Rivets 3. Hoist and support vehicle on safety st ...

See also:

Actuator, mode door, front
DESCRIPTION Fig. 12: Blend Door Actuators The mode door actuator (1) for the heating-A/C system is a reversible, 12-volt Direct Current (DC) servo motor, which is mechanically connected to the ...

Pulley, idler
Removal 2.4L ENGINE Fig. 30: ACCESSORY DRIVE BELT IDLER PULLEY - 2.4L - UPPER PULLEY - LOWER PULLEY 1. Remove accessory drive belt. 2. Remove upper idler pulley (1) and bolt. 3. Re ...

Description, Operation
DESCRIPTION Fig. 284: Rear Evaporator Description The rear A/C evaporator (4) is located within the rear heater-A/C housing, behind the right interior quarter panel trim. The rear A/C evaporato ...