FLUIDS, LUBRICANTS, AND GENUINE PARTS

Engine Chassis ...

EMISSIONS CONTROL SYSTEM MAINTENANCE

The Scheduled Maintenance services listed in bold type, must be done at the times or mileages specified to ensure the continued proper functioning of the Emissions Control System. These, and all ot ...

See also:

Wheel alignment
PRE-WHEEL ALIGNMENT INSPECTION Before any attempt is made to change or correct the wheel alignment, the following inspection and necessary corrections must be made to the vehicle to ensure proper ...

Assembly
Fig. 214: First Gear Needle Bearing & Output Shaft NOTE: Use ATF on all parts that are to be assembled in this procedure. 1. Install the first and first gear needle bearing (2) on the out ...

ENGINE BLOCK HEATER — IF EQUIPPED
The engine block heater warms engine coolant and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord. ...