Dodge Journey: REPLACEMENT BULBS
All the inside bulbs are brass or glass wedge base.
Aluminum base bulbs are not approved and should not be used for replacement.
LIGHT BULBS – Interior Bulb Number
Courtesy/Reading Lamps (Incandescent). . . . . . . . 578. Courtesy/Reading Lamps. (Optional LED) . . . . . . . . . . . . . . . . . . . . . . . . . LED. (Serviced at Authorized Dealer). Glove Box Lamp . . . . . . . . . . . . . . . . . . . . . . . . . 194. Cargo Lamp . . . . . . . . . . . . . . . . . . . . . . . . . . . . 579. Optional Door Map. Pocket/Cupholder . . . . . . . . . . . . . . . . . . . . . . . LED. (Serviced at Authorized Dealer).
LIGHTS BULBS – Exterior Bulb No.
Low Beam Headlamp. . . . . . . . . . . . . . . . . . .
. . 9006.
High Beam Headlamp . . . . . . . . . . . . . . . . . . . . 9005.
Front Park/Turn Signal . . . . . . . . . . . . . . . . . 3757AK.
Side Marker Lamp. . . . . . . . . . . . . . . . . . . . . . . . 168.
Front Fog Lamp . . . . . . . . . . . . . . . . . . . . . . PSX24W.
Center High Mounted Stop Lamp
(CHMSL) . . . . . . . LED (Serviced at Authorized Dealer)
Rear Tail/Stop/Turn Signal . . . . . . . . . . . . . . . 3157K.
Rear Tail . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3157K.
Backup Lamp . . . . . . . . . . . . . . . . . . . . . . . . . 3157K.
License Lamp . . . . . . . . . . . . . . . . . . . . . . . . . . . 168.
VEHICLE STORAGE
If you will not be using your vehicle for more than
21 days you may want to take steps to preserve your
battery. You may:
• Remove the IOD (Ignition Off-Draw) mini-fuses from
the Totally Integra ...
BULB REPLACEMENT
Low Beam Headlamp, High Beam Headlamp,
Front Turn Signal/Park Lamp, Side Marker Lamp
1. Open the hood.
NOTE: It may be necessary to remove the air cleaner
filter housing and position the Totally I ...
See also:
TRAILER TOWING
In this section, you will find safety tips and information
on limits to the type of towing you can reasonably do
with your vehicle. Before towing a trailer, carefully
review this information to tow ...
Installation
2.4L
Fig. 7: Capacitor 2.4L
- Bolt
- Capacitor
- Connector
1. Install ignition coil capacitor (2) and bolt (1), tighten bolt to 10 N.m
(88.5 ft. lbs.).
2. Connect electrical connect ...
WARNINGS AND CAUTIONS
This Owners Manual contains WARNINGS against operating
procedures that could result in an accident or
bodily injury. It also contains CAUTIONS against procedures
that could result in damage to your ...