Dodge Journey: HAZARD WARNING FLASHER

switch is located in theThe Hazard Warning flasher
switch is located in the instrument panel switch bank, above the climate controls.

Press the switch to turn on the Hazard Warning flasher. When the switch is activated, all directional turn signals will flash on and off to warn oncoming traffic of an emergency. Press the switch a second time to turn off the Hazard Warning flasher.

This is an emergency warning system and it should not be used when the vehicle is in motion. Use it when your vehicle is disabled and it is creating a safety hazard for other motorists.

When you must leave the vehicle to seek assistance, the Hazard Warning flasher will continue to operate even though the ignition switch is in the LOCK position.

NOTE: With extended use, the Hazard Warning flasher may wear down your battery.

    IF YOUR ENGINE OVERHEATS
    In any of the following situations, you can reduce the potential for overheating by taking the appropriate action. • On the highways — Slow down. • In city traffic — While stopped, put the ...

    See also:

    Removal
    BEVERAGE COOLER WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate t ...

    Removal
    FRONT 1. Raise and support the vehicle. Fig. 163: TIRE AND WHEEL MOUNTING 2. Remove the wheel mounting nuts (3), then the tire and wheel assembly (1). NOTE: In some cases, it may be necessary ...

    Installation
    SATELLITE AUDIO ONLY NOTE: The antenna cables are integrated into the body wiring harnesses. New antenna cables is overlaid on the body wiring harness. 1. Route the cable behind the glove ...

    0.0088