Dodge Journey: STARTING AND OPERATING
Dodge Journey Owners Manual / STARTING AND OPERATING
- STARTING PROCEDURES
- ENGINE BLOCK HEATER — IF EQUIPPED
- AUTOMATIC TRANSMISSION
- AUTOSTICK — IF EQUIPPED
- ALL WHEEL DRIVE (AWD) — IF EQUIPPED
- DRIVING ON SLIPPERY SURFACES
- DRIVING THROUGH WATER
- POWER STEERING
- PARKING BRAKE
- BRAKE SYSTEM
- ELECTRONIC BRAKE CONTROL SYSTEM
- TIRE SAFETY INFORMATION
- TIRES — GENERAL INFORMATION
- TIRE CHAINS
- SNOW TIRES
- TIRE ROTATION RECOMMENDATIONS
- TIRE PRESSURE MONITOR SYSTEM (TPMS)
- FUEL REQUIREMENTS
- ADDING FUEL
- VEHICLE LOADING
- TRAILER TOWING
- RECREATIONAL TOWING (BEHIND MOTORHOME, ETC.)
CLIMATE CONTROLS
The Climate Control System allows you to regulate the
temperature, amount, and direction of air circulating
throughout the vehicle. The controls are located in the
center stack of the instrument pa ...
STARTING PROCEDURES
Before starting your vehicle, adjust your seat, adjust the
inside and outside mirrors, fasten your seat belt, and if
present, instruct all other occupants to buckle their seat
belts.
WARNING:
Nev ...
See also:
TOWING A DISABLED VEHICLE
Without The Ignition Key
Front Wheel Drive (FWD)
Special care must be taken when the vehicle is towed
with the ignition in the LOCK position. Flatbed towing is
the preferred towing method. However ...
Seal(s), valve guide
REMOVAL
Fig. 139: Valve Stem Seal-Removal/Installation
- VALVE SEAL TOOL
- VALVE STEM
1. Remove valve spring.
2. Remove valve stem seal by using a valve seal tool.
INSTALLATION
Fig. ...
Description, Operation
DESCRIPTION
Fig. 29: Removing/Installing ECM - 2.0L Diesel
The ECM (3) is located in the left side of engine compartment attached to the
left inner fender below the air
filter housing.
OPERAT ...
