Dodge Journey: PARKVIEW REAR BACK UP CAMERA — IF EQUIPPED

Your vehicle may be equipped with the ParkView Rear Back Up Camera that allows you to see an on-screen image of the rear of your vehicle whenever the shift lever is put into REVERSE. The image will be displayed on the Navigation/Multimedia radio display screen.

WARNING:
Drivers must be careful when backing up even when using the ParkView Rear Back Up Camera. Always check carefully behind your vehicle, and be sure to check for pedestrians, animals, other vehicles, obstructions, or blind spots before backing up. You are responsible for the safety of your surroundings and must continue to pay attention while backing up.

Failure to do so can result in serious injury or death.

CAUTION:
• To avoid vehicle damage, ParkView should only be used as a parking aid. The ParkView camera is unable to view every obstacle or object in your drive path.

• To avoid vehicle damage, the vehicle must be driven slowly when using ParkView to be able to stop in time when an obstacle is seen. It is recommended that the driver look frequently over his/ her shoulder when using ParkView .

NOTE: If snow, ice, mud, or anything else builds up on the camera lens, clean the lens, rinse with water, and dry with a soft cloth. Do not cover the lens.

Turning ParkView On or Off — With Navigation/Multimedia Radio

1. Press the “menu” hard key.

2. Select “system setup” soft key.

3. Press the “camera setup” soft key.

4. Enable or disable the rear camera feature by selecting “enable rear camera in reverse” soft key.

5. Press the “save” soft key.

6. When the vehicle is shifted into REVERSE, an image of the rear of the vehicle will appear with a caution note to “check entire surroundings” displayed across the top of the screen. After five seconds this note will disappear.

7. When the vehicle is shifted out of REVERSE, the rear camera mode is exited and the navigation or audio screen appears again.

Turning ParkView On or Off — Without Navigation/Multimedia Radio

1. Press the “menu” hard key.

2. Select “system setup” soft key.

3. Enable or disable the rear camera feature by selecting “enable rear camera in reverse” soft key.

4. When the vehicle is shifted into REVERSE, an image of the rear of the vehicle will appear with a caution note to “check entire surroundings” displayed across the top of the screen.

5. When the vehicle is shifted out of REVERSE, the rear camera mode is exited and the audio screen appears again.

    ELECTRONIC SPEED CONTROL — IF EQUIPPED
    When engaged, the Electronic Speed Control takes over the accelerator operation at speeds greater than 25 mph (40 km/h). The Electronic Speed Control lever is located on the right side of the stee ...

    OVERHEAD CONSOLE
    The overhead console contains courtesy/reading lights, storage for sunglasses, an interior observation mirror and an optional power sunroof switch. Overhead Console Courtesy/Reading Lights Refe ...

    See also:

    Installation
    NOTE: LHD model shown in illustrations. RHD model similar. RIGHT FRONT FLOOR DUCT Fig. 71: Duct-Right Front Floor PM NOTE: Illustration shown with instrument panel removed for clarity. ...

    Cable, gearshift control
    REMOVAL Fig. 161: Shift Cables & Bracket 1. Remove the shifter. 2. Raise hood. 3. Remove the resonator. 4. Remove engine cover. 5. Remove air cleaner assembly. 6. Disconnect ne ...

    Cooler and lines, oil
    Description Fig. 250: Oil Cooler Fasteners Some 2.7L engines may be equipped with an engine oil cooler (2) that is mounted to the rear transmission mount bracket. Oil lines route oil from the e ...

    0.0118