Dodge Journey: Shaft, output, number 1

Seal, axle drive shaft
REMOVAL Fig. 197: Axle Shaft Seal Removal 1. Remove axle shaft. 2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1). 3. Tap on the pry tool (2) with a small hammer and ...

Disassembly
Fig. 200: Snap Ring At Output Shaft Case Bearing 1. Remove the snap ring (2) from the output shaft. Fig. 201: Output Shaft Case Bearing And Gear 2. Use Bearing Splitter P-334 (3), Cage 8925-3 ( ...

See also:

Description, Operation
DESCRIPTION Fig. 1: Battery Components This vehicle is equipped with a single 12-volt battery. All of the components of the battery system are located in the front of the vehicle, just ahead of ...

Installation
Fig. 186: Rear Heater AC Housing Removal/Installation NOTE: MTC rear heater-A/C system shown. ATC system similar. 1. Position the rear heater-A/C housing (1) into the vehicle and align the ...

Fascia, front
REMOVAL Fig. 1: Pushpins 1. Release hood latch and open hood. 2. Remove the pushpins for the fascia (2) at the radiator support. Fig. 2: Pop Rivets 3. Hoist and support vehicle on safety st ...

0.5269