Installation

Fig. 474: Removing/Installing Valve Body - VALVE BODY NOTE: If valve body assembly is being replaced or reconditioned, it is necessary to perform the PCM Quick Learn Procedure. 1. ...

Description

Fig. 1: BG6 Manual Transaxle - OUTPUT SHAFT #2 - INPUT SHAFT - OUTPUT SHAFT #1 - DIFFERENTIAL The Aisin BG 6 6-speed transaxle is a constant-mesh transaxle that is synchronized in all ...

See also:

Removal
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow these instructions may result in serious or fatal ...

Installation
LEFT-HAND DRIVE 1. Clean any debris off the mating surfaces of the HCU and ABM. CAUTION: When installing new O-rings or solenoid valve stem seals, do not use any type of lubricant. ...

Actuator, blend door, rear
DESCRIPTION Fig. 47: Rear Actuator Description The blend door actuator (1) for the rear heating-A/C system is a reversible, 12 volt direct current (DC), servo motor. The rear blend door actuato ...