Sensor, variable line pressure

DESCRIPTION Fig. 390: Identifying Variable Line Pressure Sensor - PRESSURE CONTROL SOLENOID - LINE PRESSURE SENSOR - SHOULDER SCREW - VARIABLE LINE PRESSURE HEADER - MANUAL SHAFT - SC ...

Removal

Fig. 393: Removing/Installing Defroster Cover 1. Disconnect the negative battery cable. 2. Using a trim stick remove the defroster cover (1). Fig. 394: Removing/Installing Screws At Center St ...

See also:

Description, Operation
DESCRIPTION Fig. 2: Antilock Brake Module - ANTILOCK BRAKE MODULE (ABM) - HYDRAULIC CONTROL UNIT (HCU) - PUMP/MOTOR The Antilock Brake Module (ABM) is a microprocessor-based device which ...

Removal
LEFT-HAND-DRIVE CAUTION: The vacuum in the power brake booster must be pumped down before removing the master cylinder to prevent the booster from sucking in any contamination. This ...

Removal
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow these instructions may result in serious or fat ...