Cable, shift

REMOVAL Fig. 306: Identifying Knee Blocker 1. Remove the knee blocker (2). Fig. 307: Identifying Shift Cable At Shifter NOTE: Ensure the lock tab on the shift cable (2) is depressed before ...

Description, Operation

DESCRIPTION Fig. 313: Identifying Differential Assembly - DIFFERENTIAL CASE - RING GEAR - TRANSFER SHAFT - PINION GEAR - PINION SHAFT - SIDE GEAR The 41TE differential is a convent ...

See also:

Ring(s), piston
Standard Procedure PISTON RING FITTING Fig. 200: CHECK GAP ON PISTON RINGS - FEELER GAUGE 1. Wipe cylinder bore clean. Insert ring and push down with piston to ensure it is square in bore ...

Assembly
Fig. 214: First Gear Needle Bearing & Output Shaft NOTE: Use ATF on all parts that are to be assembled in this procedure. 1. Install the first and first gear needle bearing (2) on the out ...

Installation
Two unique brake lamp switches are used in this vehicle, depending upon whether the vehicle was built during early or late production. These switches are not interchangeable. Both switches are il ...