Assembly

Fig. 257: Installing Input Shaft - INPUT SHAFT - ARBOR PRESS - INPUT SHAFT HUB ASSEMBLY Use petrolatum on all seals to ease assembly of components. 1. Using an arbor press (2), install ...

Description, Operation

DESCRIPTION Fig. 297: Identifying Solenoid/Pressure Switch Assembly - SOLENOID AND PRESSURE SWITCH ASSEMBLY The Solenoid/Pressure Switch Assembly (1) is external to the transaxle and mount ...

See also:

Duct, floor distribution, rear
REMOVAL Fig. 159: Rear Floor Distribution Duct 1. Remove right quarter trim panel. 2. Remove the push-pin retainer (2) that secures the rear floor distribution duct (1) to the right inner qu ...

Disassembly
Fig. 200: Snap Ring At Output Shaft Case Bearing 1. Remove the snap ring (2) from the output shaft. Fig. 201: Output Shaft Case Bearing And Gear 2. Use Bearing Splitter P-334 (3), Cage 8925-3 ( ...

Installation
DIESEL PARTICULATE FILTER Fig. 12: Engine Support Bracket Bolts 1. Position the DPF and turbocharger gasket into the vehicle. Do not tighten at this time 2. Tighten the three bolts (1) at the ...