Accumulator

DESCRIPTION Fig. 238: Identifying Underdrive & Overdrive Accumulators - RETURN SPRING - UNDERDRIVE CLUTCH ACCUMULATOR - SEAL RING (2) - OVERDRIVE CLUTCH ACCUMULATOR The 41TE underd ...

Disassembly

Fig. 241: Tapping Down Reverse Clutch Reaction Plate - #4 THRUST PLATE (SELECT) - TAP DOWN REVERSE CLUTCH REACTION PLATE TO REMOVE OR INSTALL SNAP RING - INPUT SHAFT CLUTCHES RETAINER ASSEMB ...

See also:

DRIVING ON SLIPPERY SURFACES
Acceleration Rapid acceleration on snow covered, wet, or other slippery surfaces may cause the front wheels to pull erratically to the right or left. This phenomenon occurs when there is a differe ...

Bearing(s), crankshaft, main
Standard Procedure CRANKSHAFT MAIN BEARING FITTING Fig. 169: Cylinder Block Main Bore Grade Marking The grade marks for the cylinder block main bearing bore grade is located on the pan rail jus ...

Installation
NOTE: Perform 1 through 5 on each side of the vehicle to complete pad set installation, then proceed to 6. NOTE: Make sure that the audible wear indicator (if equipped) is placed toward ...