Toe

Fig. 115: Steering Wheel Holding Tool 1. Center the steering wheel and lock it in place using a steering wheel clamp. NOTE: When setting toe, make sure to set rear toe to the preferred spe ...

Automatic Transmission 41TE

...

See also:

Removal
2.4L Fig. 45: Locating Knock Sensor The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold. 1. Disconnect and isolate negative battery ca ...

Seal, oil pump
REMOVAL Fig. 367: Removing Oil Pump Seal - SEAL PULLER C-3981-B - OIL PUMP SEAL 1. Remove transaxle from vehicle. 2. Using Seal Puller C-3981B (1) , remove oil pump seal (2). INSTALLA ...

With intermediate shaft
NOTE: The inner tripod joints are designed with a retention feature that prevents the tripod rollers from coming out of the inner joint housing up to a specific load. If this feature is o ...