Dodge Journey: Standard procedure

Description
Vehicle wheel alignment is the positioning of all interrelated front and rear suspension angles. These angles affect the handling and steering of the vehicle when it is in motion. Proper wheel al ...

Curb height measurement
The wheel alignment is to be checked and all alignment adjustments made with the vehicle at its required curb height specification. Vehicle height is to be checked with the vehicle on a flat, le ...

See also:

Installation
1. Guide the trailing end of the parking brake cable along the inboard side of the axle trailing arm up to the rear brake caliper. Make sure the cable is routed between the brake line and the tra ...

Description
MANUAL TEMPERATURE CONTROL (MTC) SINGLE ZONE The A/C-heater control for the front Manual Temperature Control (MTC) single zone system allows one temperature setting for the entire vehicle. All con ...

Assembly
Fig. 65: Remove Input Shaft Bearing Cup NOTE: Always use ATF on all moving parts during this assembly procedure. 1. Use Bearing Cup Remover 9664 (2) and appropriate Slide Hammer (1) to r ...

0.0166