Installation

NOTE: Before stabilizer bar installation, inspect the cushions and links for excessive wear, cracks, damage and distortion. Replace any pieces failing inspection. NOTE: Before installing the ...

Description, Operation

DESCRIPTION A Macpherson type design strut assembly is used in place of the traditional front suspension upper control arm and upper ball joint. The bottom of the strut mounts directly to the stee ...

See also:

Tube, air pump, inlet
Description The air pump inlet tube is located on the left side of the engine compartment. The tube attaches to the air injection pump using a quick connect style fitting. The other end of the tub ...

AUTOSTICK — IF EQUIPPED
AutoStick is a driver-interactive transmission that offers six manual ratio changes to provide you with more control of the vehicle. AutoStick allows you to maximize engine braking, eliminate undes ...

Crossmember, front fore and aft
REMOVAL 1. Raise and support the vehicle. 2. If equipped, remove the engine belly pan. Fig. 29: Removing/Installing Fore/Aft Crossmember 3. Remove the front engine mount thru-bolt (2). Fig ...