Hub and bearing

DESCRIPTION Fig. 31: Front Hub And Bearing Mounting The front wheel bearing and wheel hub of this vehicle are a one piece sealed unit or hub and bearing unit type assembly. The hub and beari ...

Description, Diagnosis and Testing

DESCRIPTION Fig. 38: Front Hub And Bearing Mounting The knuckle (3) is a single casting with legs machined for attachment to the front strut assembly on the top and steering linkage on the trai ...

See also:

Cooler and lines, oil
Description Fig. 250: Oil Cooler Fasteners Some 2.7L engines may be equipped with an engine oil cooler (2) that is mounted to the rear transmission mount bracket. Oil lines route oil from the e ...

Cleaning, Inspection
CLEANING Drain cooling system and refill with clean water. Refer to drain and fill procedures in this service information . Run engine with radiator cap installed until upper radiator hose is ho ...

Assembly
Fig. 214: First Gear Needle Bearing & Output Shaft NOTE: Use ATF on all parts that are to be assembled in this procedure. 1. Install the first and first gear needle bearing (2) on the out ...