Arm, lower control

Diagnosis and Testing LOWER CONTROL ARM Inspect the lower control arm for signs of damage from contact with the ground or road debris. If the lower control arm shows any sign of damage, look for ...

Diagnosis and Testing

LOWER BALL JOINT 1. Raise the vehicle allowing the front suspension to hang. 2. Remove the tire and wheel assembly. 3. Using Dial Indicator C-3339A, or equivalent, attach the dial indicator mou ...

See also:

Removal
NOTE: The antenna cables are integrated into the body wiring harnesses. New antenna cables is overlaid on the body wiring harness. SATELLITE AUDIO ONLY 1. Disconnect and isolate the batter ...

Removal
2.4L Fig. 45: Locating Knock Sensor The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold. 1. Disconnect and isolate negative battery ca ...

Standard Procedure
MASTER CYLINDER BLEEDING 1. Clamp the master cylinder in a vise with soft-jaw caps. Fig. 88: BLEEDING MASTER CYLINDER WITH ABS 2. Thread a Bleeder Tube (2), Special Tool 8358-1, into the primary ...