Installation

CLUTCH - FIXED DISPLACEMENT A/C COMPRESSOR NOTE: Typical A/C compressor and clutch assembly shown in illustrations. Fig. 214: Clutch Coil & Snap Ring 1. Align the dowel pin on the bac ...

Description, Operation

DESCRIPTION Fig. 221: Condenser Description NOTE: A/C condenser with automatic transmission cooler shown. A/C Condenser without cooler similar. The A/C condenser (1) is located in the f ...

See also:

Installation
Fig. 67: Seal Protector - HALFSHAFT - SEAL PROTECTOR 1. Install driveline module to transmission jack. Secure module to jack. 2. Using Seal Protector 9099 (2), load halfshafts to differe ...

Bearing(s), crankshaft, main
Standard Procedure CRANKSHAFT MAIN BEARING FITTING Fig. 169: Cylinder Block Main Bore Grade Marking The grade marks for the cylinder block main bearing bore grade is located on the pan rail jus ...

Cover(s), engine timing
Removal Fig. 349: FRONT SPLASH SHIELDS 1. Disconnect and isolate negative battery cable. 2. Drain cooling system. 3. Remove coolant pressure container. 4. Remove right front wheel and bel ...