Dodge Journey: Description, Operation

DESCRIPTION

The A/C refrigerant lines and hoses are used to carry the refrigerant between the various A/C system components. The refrigerant lines and hoses for the R-134a A/C system consist of a barrier-hose design with a nylon tube sandwiched between rubber layers. The nylon tube helps to contain the R-134a refrigerant, which has a small molecular structure. The ends of the refrigerant lines are made from lightweight aluminum and brazed fittings.

Any kinks or sharp bends in the refrigerant lines and hoses will reduce the capacity of the entire A/C system and can reduce the flow of refrigerant within the system.

OPERATION

High pressures are produced in a refrigerant system when the A/C compressor is operating. Extreme care must be exercised to make sure that each of the refrigerant system connections is pressure-tight and leak free. It is a good practice to inspect all flexible hose refrigerant lines at least once a year to make sure they are in good condition and properly routed.

Depending on vehicle, model and market application, refrigerant lines are connected to each other or other A/C system components with block-type or quick-connect type fittings. To ensure the integrity of the refrigerant system, O-rings and/or gaskets may be used to seal the refrigerant system connections.

The refrigerant lines and hoses cannot be repaired and must be replaced if leaking or damaged.

    Warning, Caution
    WARNING WARNING: The A/C system contains refrigerant under high pressure. Repairs should only be performed by qualified service personnel. Serious or fatal injury may result from ...

    See also:

    Frame
    SPECIFICATIONS FRAME DIMENSIONS Frame dimensions are listed in metric scale. All dimensions are from center to center of Principal Locating Point (PLP), or from center to center of PLP and fasten ...

    Description, Operation
    DESCRIPTION Fig. 29: Removing/Installing ECM - 2.0L Diesel The ECM (3) is located in the left side of engine compartment attached to the left inner fender below the air filter housing. OPERAT ...

    Description, Operation
    DESCRIPTION NOTE: LHD model shown. RHD model similar. Fig. 226: Heater Core-Description The heater core (1) for the heating-A/C system is mounted within the HVAC air distribution housing, ...

    0.0089