Installation

BEVERAGE COOLER NOTE: LHD model shown in illustrations. RHD model similar. OUTLET Fig. 149: Beverage Cooler Outlet & Hose NOTE: If the beverage cooler cold air supply hose falls back ...

Duct, ceiling distribution

REMOVAL WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negati ...

See also:

Resistor, blower motor, rear
DESCRIPTION Fig. 62: Rear Blower Resistor A blower motor resistor is used on this model when equipped with the manual temperature control (MTC) rear heating-A/C system. Models equipped with the ...

Operation
FIXED DISPLACEMENT A/C COMPRESSOR The Denso 10SR15 and 10SR17 fixed displacement A/C compressors are driven by the engine through an electric clutch, drive pulley and belt arrangement. These A/C c ...

Electronically controlled clutch
REMOVAL NOTE: Rubber coupler is part of the propeller shaft assembly. Removing coupler from propeller shaft will result in vibration/balance issues. Fig. 95: Removing /Installing Propell ...