Removal, Installation

REMOVAL WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negati ...

Description

Fig. 142: Instrument Panel Outlets There are two defroster air outlets (1) in the defroster grille (2) located at the top of the instrument panel. The airflow from the defroster outlets are dire ...

See also:

Installation
Fig. 186: Rear Heater AC Housing Removal/Installation NOTE: MTC rear heater-A/C system shown. ATC system similar. 1. Position the rear heater-A/C housing (1) into the vehicle and align the ...

Installation
Fig. 40: Seal Protector - HALFSHAFT - SEAL PROTECTOR 1. Install halfshaft to hub/bearing assembly. Install hub nut and washer but do not tighten at this time. 2. Using Seal Protector 9 ...

Removal
2.4L Fig. 45: Locating Knock Sensor The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold. 1. Disconnect and isolate negative battery ca ...