Installation

HOUSING-AIR DISTRIBUTION NOTE: LHD model shown in illustrations. RHD model similar. Fig. 131: Air Distribution Housing-Removal/Installation 1. Position the air distribution housing (2) onto ...

Description, Operation

DESCRIPTION Fig. 139: Blower Motor-PM The blower motor (1) is used to control the velocity of air moving through the HVAC housing by spinning the blower wheel (2) within the HVAC air inlet hous ...

See also:

Motor, blower, rear
DESCRIPTION Fig. 191: Rear Blower The rear blower motor (1) is a 12-volt, direct current (DC) motor mounted within a plastic housing with an integral wire connector (4) and a squirrel cage-type ...

Installation
2.4L Fig. 52: 2.4L Knock Sensor CAUTION: Always torque knock sensors to the correct torque specification. Over or under tightening effects knock sensor performance. Ensure the electr ...

Removal, Installation
REMOVAL REMOVAL - NGC CONTROLLER Fig. 39: Remove/Install PCM NOTE: USE THE SCAN TOOL TO REPROGRAM THE NEW POWERTRAIN CONTROL MODULE (PCM) WITH THE VEHICLES ORIGINAL IDENTIFICATION NUMBER ( ...