Transducer, A/C pressure

DESCRIPTION Fig. 44: A/C Pressure Transducer - A/C PRESSURE TRANSDUCER The A/C pressure transducer (1) is a switch that is installed on a fitting located on the A/C liquid line at the righ ...

Actuator, blend door, rear

DESCRIPTION Fig. 47: Rear Actuator Description The blend door actuator (1) for the rear heating-A/C system is a reversible, 12 volt direct current (DC), servo motor. The rear blend door actuato ...

See also:

Installation
Fig. 137: Rear Mount Bracket 1. If transmission brackets were removed or transmission was replaced install the rear mount bracket and tighten (1) to 100 N.m (74 ft. lbs.). Fig. 138: Front Mou ...

Camshaft, engine
DESCRIPTION Fig. 108: Camshaft & Valvetrain Components - CAMSHAFT BEARING CAP - INTAKE - CAMSHAFT BEARING CAP - EXHAUST - CAMSHAFT - EXHAUST - ROCKER ARM - HYDRAULIC LIFTER - CYLI ...

Ring(s), piston
Standard Procedure PISTON RING FITTING Fig. 200: CHECK GAP ON PISTON RINGS - FEELER GAUGE 1. Wipe cylinder bore clean. Insert ring and push down with piston to ensure it is square in bore ...