Dodge Journey: Controls, front
Dodge Journey Service & Repair Manual / Heating & Air Conditioning / Controls, front
- Actuator, blend door, front
- Actuator, mode door, front
- Actuator, recirculation door
- Control, A/C and heater, front
- Module, power, front blower motor
- Resistor, blower motor, front
- Sensor, ambient temperature
- Sensor, evaporator temperature
- Sensor, infrared temperature
- Sensor, sun
- Transducer, A/C pressure
Heater performance
Before performing the following tests, see COOLING for the procedures to
check the engine coolant level and
flow, engine coolant reserve/recovery system operation, accessory drive belt
condition ...
See also:
Assembly
Fig. 65: Remove Input Shaft Bearing Cup
NOTE: Always use ATF on all moving parts during this assembly
procedure.
1. Use Bearing Cup Remover 9664 (2) and appropriate Slide Hammer (1) to
r ...
Crossmember, front suspension
REMOVAL
1. Raise and support the vehicle.
Fig. 33: Tire And Wheel Mounting
2. On each side of the vehicle, remove the wheel mounting nuts (3), then the
front tire and wheel assembly
(1).
Fi ...
Manifold, exhaust, front
Removal
1. Disconnect negative battery cable.
2. Remove the engine cover.
Fig. 295: Oxygen Sensors
3. Disconnect and remove oxygen sensors (2) and (4).
Fig. 296: Upper Maniverter Heat Shiel ...
