Dodge Journey: Sensor, knock

Installation
2.4L FRONT Fig. 38: Removing/Installing Camshaft Position Sensor CAUTION: Install camshaft position (CMP) sensor utilizing twisting motion. Make sure CMP sensor is fully seated. Do n ...

Removal
2.4L Fig. 45: Locating Knock Sensor The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold. 1. Disconnect and isolate negative battery ca ...

See also:

TO OPEN AND CLOSE THE HOOD
Two latches must be released to open the hood. 1. Pull the hood release lever located under the left side of the instrument panel. Hood Release 2. Outside of the vehicle, locate the safety latch ...

FREEING A STUCK VEHICLE
If your vehicle becomes stuck in mud, sand, or snow, it can often be moved by a rocking motion. Turn your steering wheel right and left to clear the area around the front wheels. Then shift back an ...

Assembly
NOTE: Cleanliness through entire disassembly and assembly of the valve body cannot be overemphasized. When disassembling, each part should be washed in a suitable solvent, then dried by comp ...

0.024