Plug, glow

DESCRIPTION Fig. 26: Glow Plug Glow plugs are used to help start a cold or cool engine. The glow plugs will heat up and glow to heat the combustion chamber of each cylinder. An individual glow ...

Operation, Removal

OPERATION CAMSHAFT AND CRANKSHAFT SIGNALS Fig. 29: 4 Cylinder Cam & Crank Signals NOTE: The graphic represents the relationship between camshaft and crankshaft sensors edges with cams ...

See also:

Installation
Fig. 137: Rear Mount Bracket 1. If transmission brackets were removed or transmission was replaced install the rear mount bracket and tighten (1) to 100 N.m (74 ft. lbs.). Fig. 138: Front Mou ...

Communication
DESCRIPTION The primary on-board communication network between microprocessor-based electronic control modules in this vehicle is the Controller Area Network (CAN) data bus system. A data bus ne ...

Disassembly
Fig. 200: Snap Ring At Output Shaft Case Bearing 1. Remove the snap ring (2) from the output shaft. Fig. 201: Output Shaft Case Bearing And Gear 2. Use Bearing Splitter P-334 (3), Cage 8925-3 ( ...